Engineering, 11.03.2020 01:20 charlesiarenee0

How do I design a BCD to seven-segment decoder using a single decoder and OR gates only?

Where,
The desired decimal digit is expressed in binary-coded-decimal (BCD) format, and then used as an input to a logic network which controls the seven segments.

For this project, you will develop a multiple-output logic network that drives a 7-segment display, yielding all ten decimal digits. Here is how you will proceed:

1. The input variables will be the BCD representations of the decimal digits 0-9 (use switches 0-3 on your board: SW0= LSB, SW3= MSB).

2. Using Karnaugh maps, determine the seven output functions for controlling each of the seven segments, in minimum SOP form. Using Don't Cares will greatly simplify your output functions.

3. Express the seven output functions

4. You will display the digit on the left 7-segment digit on your board. Refer to the manuals regarding how to enable a specific digit on this display. Hint: Applying a logic low level to a segment causes it to light up and applying a high level turns it off.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

You know the right answer?

How do I design a BCD to seven-segment decoder using a single decoder and OR gates only?

Questions