Engineering, 11.03.2020 02:09 treylartigue
As a general rule of thumb, the ratio of the rate of etch-product formation to the flow rate of etch gas should be greater than 0.1 for uniform etching. Suppose a 7.5-cm diameter silicon wafer is etched at a rate of 50 nm/min in a CF4 plasma.
(a) How many atoms of Si are removed per minute?
(b) What evolution rate of SiF4 does this correspond to in standard cubic centimeters per minute (sccm)?
(c) What minimum CF4 flow rate should be maintained?
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
As a general rule of thumb, the ratio of the rate of etch-product formation to the flow rate of etch...
Mathematics, 25.10.2019 20:43
Mathematics, 25.10.2019 20:43
Mathematics, 25.10.2019 20:43
Mathematics, 25.10.2019 20:43
English, 25.10.2019 20:43