Engineering, 11.03.2020 02:22 ayoismeisalex

Finished crankshafts take a lot of time and money to make, and are critical to the proper function of an automobile engine. Because of the critical nature of this part, one company measures several critical dimensions on each and every finished crankshaft. If any of the dimensions measured do not meet the engineering specifications, the crankshaft is scrapped Since measurements are being taken for inspection purposes, data is readily available for control charts as well. Dimension #11 is one of the many critical dimensions that is measured, and has been the subject of much debate. Lately, all of the crankshafts that are scrapped were scrapped because of dimension #11 being out of spec. The control charts for this dimension have been in statistical control, with a centerline on the X-bar chart of 547.9, and a centerline on the R-chart of 10.23. (Subgroups were formed by taking the first 5 crankshafts inspected each hour to form subgroups of n-6). Specifications for dimension #11 are 550.0 ± 10.0 (Assume a normal distribution of all characteristics measured when working this problem.) a) Using the above information, estimate the percentage of crankshafts that would not meet the specs for dimension #11 . Calculate Z-scores, and use the "Z-table" to find your answer.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

Finished crankshafts take a lot of time and money to make, and are critical to the proper function o...

Questions