Engineering, 11.03.2020 05:28 caguil00

Recall that the maximum heat transfer possible is the product of the minimum heat capacity (mass flow rate times specific heat) times the difference between the hot and cold side inlet temperatures. Address the following questions related to heat exchanger effectiveness. a. Sketch the temperature profiles for a 50% and 80% effectiveness heat exchanger. (As with Problem 1, make sure you have the correct shape, which, including degree of steepness at each end). b. What is the effectiveness for a heat exchanger with the following characteristics: the hot side is water entering at 160 F and 2lb/s, and the cold side is air entering at 20 F and 4 lb/s. The HX has been designed to the correct shape, which, including degree of steepness at each end). b. achieve an air outlet of 110 F.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

You know the right answer?

Recall that the maximum heat transfer possible is the product of the minimum heat capacity (mass flo...

Questions