Engineering, 11.03.2020 17:42 alevans7144

You want to know your grade in Computer Science, so write a program that continuously takes grades between 0 and 100 to standard input until you input "stop", at which point it should print your average to standard output. Instructor Notes: Make sure to initialize counter and total to 0 Read the grades between 0 and 100: grade = input() Use while loop as long as the grades input is not equal to "stop" Make sure to total int(grades) Increment counter by one input the grade again Finally, print the average: total/counter

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

Engineering, 06.07.2019 03:30

The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory

Answers: 3

Answer

You know the right answer?

You want to know your grade in Computer Science, so write a program that continuously takes grades b...

Questions