Engineering, 11.03.2020 18:27 jaymariepope3334

Problem 2: Sieve Analysis and Soil Gradation
Using the plot below
A. Determine the percent gravet, sand and lines (silt clay), remembering that:
a. Mgravel Passing 3 in (75 mm) and retained on 04 (4.75 mm)
b. % sand Passing #4 (4.75 mm) and retained on #200 (0.075 mm)
6% silt and clay - Passing #200 (0.075 mm)
B. Determine Dio. Do Do Mark these values on the graph.
C. Determine the uniformity coefficient and coefficient of gradation (G. and C.),
D. Using the Cu and C, determine whether the soil is well, poorly or gap graded
34in No.4
9.8an No.10
No. 100
No. 40 No. 200
Steve Number
% passing
D50
100
10
0.1
001
0.001
Grain Diameter (mm)

Problem 2: Sieve Analysis and Soil GradationUsing the plot belowA. Determine the percent gravet, san

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

You know the right answer?

Problem 2: Sieve Analysis and Soil Gradation
Using the plot below
A. Determine the percent...

Questions