subject
Engineering, 12.03.2020 21:54 xxaurorabluexx

Long carbon steel shafts (k = 51.2 W/mºC,  = 1.21  10-5 m2 /s) of 0.1 m diameter are treated in a gas-fired furnace whose gases are at 927 ºC and provide a convection coefficient of 100 W/m2 ºC. The shafts enter the furnace at 27 ºC. Disregard radiation heat transfer. Determine the time (s) the shafts must remain in the furnace to achieve a centerline temperature of 527 ºC.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Long carbon steel shafts (k = 51.2 W/mºC,  = 1.21  10-5 m2 /s) of 0.1 m diameter are treated in a...
Questions
question
Mathematics, 15.04.2021 19:20
question
Biology, 15.04.2021 19:20
question
Mathematics, 15.04.2021 19:20
question
Mathematics, 15.04.2021 19:20
Questions on the website: 13722360