Engineering, 13.03.2020 00:02 fun1togo
Flank wear data were collected in a series of turning tests using a coated carbide tool on hardened alloy steel at a feed of 0.30 mm/rev and a depth of 4.0 mm. At a speed of 125 m/min, the tool life is 20.4 min. At a speed of 165 m/min, the tool life is 10 min. Calculate the values of n and C in the Taylor equation for tool life.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
Flank wear data were collected in a series of turning tests using a coated carbide tool on hardened...
Questions
History, 13.11.2019 23:31
Social Studies, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Biology, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
Mathematics, 13.11.2019 23:31
