Engineering, 13.03.2020 18:31 pandasarecute53

The value of ΔHrxn for Reaction 3 in Part B was determined by three different methods: (1) The "theoretical" value was determined in Step 2 (and Step 6) of the Data Analysis, (2) the experimental value was determined using Hess’ Law of Summation, and (3) the value was obtained directly by measuring the temperature change for Reaction 3. How did these three values of ΔHrxn compare? Was the ΔHrxn obtained in Step 5 of the Data Analysis accurate? Explain. Do the results of this experiment support Hess’s Law?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

You know the right answer?

The value of ΔHrxn for Reaction 3 in Part B was determined by three different methods: (1) The "theo...

Questions