Engineering, 13.03.2020 21:23 rosieposie27

Part A What is the correct expression of the internal moment in segment AB? A 10-ft-long cantilever beam is fixed at end A (x = 0). A uniform distributed load of 2 kip/ft is applied between A and B (x = 6 ft). A downward 10-kip force is applied at B, and an upward 8-kip force is applied at end C (x = 10 ft). In addition, a clockwise couple moment of 40 kip-ft is exerted at the free end C. What is the correct expression of the internal moment in segment AB? A 10-ft-long cantilever beam is fixed at end A (x = 0). A uniform distributed load of 2 kip/ft is applied between A and B (x = 6 ft). A downward 10-kip force is applied at B, and an upward 8-kip force is applied at end C (x = 10 ft). In addition, a clockwise couple moment of 40 kip-ft is exerted at the free end C. −x2 (kip-ft) −x2+14x (kip-ft) −x2+14x+24 (kip-ft) −x2−56 (kip-ft) −x2+24 (kip-ft) −x2+14x−56 (kip-ft)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

You know the right answer?

Part A What is the correct expression of the internal moment in segment AB? A 10-ft-long cantilever...

Questions