Engineering, 13.03.2020 22:02 live4dramaoy0yf9

Design worksheet problem (2 points) - Create your own design calculator problem: You’re going to design a spring to be used in combination with a linear dashpot to form a ""shock absorber"". See figures below for the following terms. D refers to the mean coil diameter and d is the wire diameter. The ID of the spring should be greater than 1 inch so that you can slide the dashpot inside. The ""max loaded length"" in a dynamic scenario is 1.5 inches at 75 pounds and the free length is 3 inches. The spring has ground plane ends such that the solid height will be: = ( + 2). Assume that the Wahl factors are K = 1.15 and that you have to keep torsional stress below 100ksi

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

Design worksheet problem (2 points) - Create your own design calculator problem: You’re going to des...

Questions