Engineering, 13.03.2020 22:50 meli6552

He following waveforms are measured through a particular device: LaTeX: v(t)= 20\cos(100t+50^{\circ})Vv ( t ) = 20 cos ⁡ ( 100 t + 50 ∘ ) V LaTeX: i(t)=15\cos(100t-5^\circ)Ai ( t ) = 15 cos ⁡ ( 100 t − 5 ∘ ) A What is the power angle? Submit your answer in degrees, while omitting the unit.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump

Answers: 2

Answer

Engineering, 06.07.2019 04:30

Asharp-edged orifice is placed in a 10-in-diameter pipe carrying ammonia. if the volume flow rate is 25 gal/min, calculate the deflection of a water manometer (a) if the orifice diameter is 1.0 in and (b) if the orifice diameter is 7.0 in. the ammonia has a specific gravity of 0.83 and a dynamic viscosity of 2.5 x 10-6 lb s/t2

Answers: 3

Answer

Engineering, 06.07.2019 05:20

A8-in.-diameter steel shaft is to have a press fit with a 16-in-diameter cast iron hub. both the hub and the shaft are 10 in long. using maximum normal stress theorem and appropriate safety factor, it was identified that the maximum allowable circumferential (a.k.a. hoop or tangential) stress in the hub is to be 7.5 ksi. the moduli of elasticity are 30 x 106 psi for steel and 15 x 106 psi for cast iron. the poisson's ratio for both steel and cast ron is 0.3 and coefficient friction for the two materials is 0.12. determine a. the interference or the original mismatch, 8 b. the maximum axial force required to press the hub on the shaft

Answers: 1

Answer

You know the right answer?

He following waveforms are measured through a particular device: LaTeX: v(t)= 20\cos(100t+50^{\circ}...

Questions