Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
What tools are required to fix a rear derailleur...
Questions
Mathematics, 14.07.2021 22:00
Mathematics, 14.07.2021 22:00
Mathematics, 14.07.2021 22:00
English, 14.07.2021 22:00
Mathematics, 14.07.2021 22:10
Mathematics, 14.07.2021 22:10
English, 14.07.2021 22:10
English, 14.07.2021 22:10
Business, 14.07.2021 22:10
Mathematics, 14.07.2021 22:10
Mathematics, 14.07.2021 22:10
Mathematics, 14.07.2021 22:10
