Engineering, 17.03.2020 20:02 jose0765678755

To analyze and design a passive, first-order high-pass filter using a series RC circuit. An instrument needs to detect periodic signals of approximately 5000 Hz. The instrument operates in an environment with a lot of periodic noise ranging from a few to several hundred hertz. A high-pass RC filter can be built using available 1.0 μF capacitors; resistors of any necessary value are also available.
1. Using the available 1.0 μF capacitor, what is the value of the resistor needed to make a high-pass filter with a cutoff frequency of 3000 Hz? Express your answer to three significant figures and include appropriate units

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

To analyze and design a passive, first-order high-pass filter using a series RC circuit. An instrume...

Questions