Engineering, 17.03.2020 22:27 nia3378

A test sample, with a cross-sectional area of 0.325 in2 and a 2.25” length, is pulled apart in a tensile test machine. The figure below shows the resulting Stress-Strain diagram. Use the information in the diagram to find the information below.

Calculate the modulus of elasticity (E) for this material using YP data:

A test sample, with a cross-sectional area of 0.325 in2 and a 2.25” length, is pulled apart in a ten

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

You know the right answer?

A test sample, with a cross-sectional area of 0.325 in2 and a 2.25” length, is pulled apart in a ten...

Questions