Engineering, 19.03.2020 18:44 YoungKukie24
G Four primary sedimentation basins are designed for total average flow of 1.2 m3/s. The TSS concentration in the primary treated effluent is 150 mg/L, and TSS removal is 63 percent. The sludge has an average solids concentration of 6 percent and specific gravity of 1.045. What is the capacity of the sludge pump in m3/min per basin if the pump is used on a 15-min pumping cycle per h
Answers: 2
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
Engineering, 04.07.2019 19:20
Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer
Answers: 1
G Four primary sedimentation basins are designed for total average flow of 1.2 m3/s. The TSS concent...
Engineering, 08.11.2020 23:10
Mathematics, 08.11.2020 23:10
History, 08.11.2020 23:10
Advanced Placement (AP), 08.11.2020 23:10
French, 08.11.2020 23:10
Mathematics, 08.11.2020 23:10
Mathematics, 08.11.2020 23:20
English, 08.11.2020 23:20
Mathematics, 08.11.2020 23:20
Mathematics, 08.11.2020 23:20
Geography, 08.11.2020 23:20