Engineering, 20.03.2020 03:20 michaeladkins1979

Which one of the following statements is true? Justify, explain every the given option.

(a) The recrystallization temperature of brass is higher than the recrystallization temperature of copper.
(b) The recrystallization temperature of bronze is lower than the recrystallization temperature of
(c) Recrystallization cannot occur at room temperature.
(d) According to the Hall-Petch equation, Ostwald ripening follows the empirical rule: copper. where n and K are material-dependent constants, / denotes time, d denotes average grain diameter at time t, and do denotes initial average grain diameter.
(E)When a cold worked material is annealed, the microstructure at time 12 is coarser than the microstructure at time ti, if /2> .

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

Answer

You know the right answer?

Which one of the following statements is true? Justify, explain every the given option.

...

Questions