Engineering, 20.03.2020 11:00 hannah2757

The data declarations for the program below are done. Remembering that data can only be manipulated in registers, add data1 to data2. Then add that sum to data3. Multiply the resulting sum by data4, then subtract data 5 from that total. Finally, take the 2’s complement of the result, store this final result in ans, and output it to the console. Before you output the answer, output the leader declared below: "Answer = " . Then output the answer you have calculated. Remember that outputting a phrase uses syscall 4.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

You know the right answer?

The data declarations for the program below are done. Remembering that data can only be manipulated...

Questions