Exercise 19
Calculate the voltage drop on each resistor and indicate the polarity of
the voltage drop on each resistor with the switch open, as indicated.
Next, calculate the voltage drop on each resistor and indicate the polarity
of the voltage drop on each resistor when the switch is closed.

Given:
Vb1 = 7V
Vb2 = 3V
R1 = 10K ohm
R2 = 5K ohm
R3 = 20K ohm
R4 = 15K ohm

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.