Engineering, 24.03.2020 01:52 crtlq

Conversions for incompressible liquids and gases are important for individual components and mixtures. Density values may be found in the Appendix or other reference books. (a) Oliver adds 183 mL of liquid acetic acid as the solvent for a chemical reaction in the laboratory. The mass (lbm) of the acetic acid is: (b) Elizabeth builds a wall of solid lead bricks as a shield from radiation. The mass of the wall is 945 lbm, so the volume (gal) of the wall is: (c) Anthony and Maria mix two liquids, ethylene glycol and water, to create a coolant for their car. Find the volume (mL) for a 12.9 lbm mixture with 0.593 mass fraction of ethylene glycol and the remaining wate

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

You know the right answer?

Conversions for incompressible liquids and gases are important for individual components and mixture...

Questions