You are taking a measurement of a signal from a sensor with high-frequency noise. In order to not amplify that noise through your instrumentation system, you decide to use an RC filter with a cutoff frequency (critical frequency, fc) of 1kHz after the sensor and before the amplification.
(a) What kind of RC filter do you need? Design the RC filter. Be sure to use standard resistor and capacitor values and specify the tolerance. Show all work.
(b) Construct the circuit using Multisim. Use the tolerances which you specified in your design.

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.