Engineering, 25.03.2020 05:57 matthewsorrow02

4. Design a transformer that will make a 15 load look like a 125 load between 50KHz and 100KHz. Choose the primary inductance to be at least 10 times the impedance of the 125 load so that the matching transformer will not significantly affect the match. Choose the number of primary windings so that you get at least the minimum inductance and can also get close to the required turns ratio using an integer number of turns for the secondary. Wind the primary and measure its inductance. Use this measured value for your simulations and actual circuits. Wind the secondary (on the same core. It can either overlap the primary windings or be separate from them if you have room). You can assume that the secondary inductance = the primary inductance divided by the turns ratio squared. L(primary) = (Show the schematic used to measure the inductance and include all work) L(secondary) =

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

Answer

Engineering, 06.07.2019 03:30

The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory

Answers: 3

Answer

Engineering, 06.07.2019 04:20

Consider a spherical container of inner radius , outer radius r2, and thermal conductivity k. express the boundary condition on the inner surface of the container for steady one-dimensional conduction for the following cases: (a) specified temperature of 50°c, (b) specified heat flux of 30 w/m2 toward the center, (c) convection to a medium at t with a heat transfer coefficient of h

Answers: 2

Answer

You know the right answer?

4. Design a transformer that will make a 15 load look like a 125 load between 50KHz and 100KHz. Ch...

Questions