Engineering, 25.03.2020 05:58 shibble21
A combined gas-steam power cycle uses a simple gas turbine for the topping cycle and a simpleRankine cycle for the bottoming cycle. Atmospheric air enters the compressor at 101 kPa and 20degC, and the maximum gas cycle temperature is 1100 degC. The compressor pressure ratio is 8;the compressor isentropic efficiency is 85 percent; and the gas turbine isentropic efficiency is 90percent. The gas stream leaves the heat exchanger at the saturation temperature of the steamflowing through the heat exchanger. Steam flows through the heat exchanger with a pressure of6000 kPa and leaves at 320 degC. The steam cycle condenser operates at 20 kPa, and the isentropic efficiency of the steam turbine is 90 percent. Determine the mass flow rate of the air through the air compressor required for this system to produce 100 MW of power. Use constant specific heats for air at room temperature. (ANSWER: 279 kg/s).
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
A combined gas-steam power cycle uses a simple gas turbine for the topping cycle and a simpleRankine...
Mathematics, 24.03.2021 20:30
English, 24.03.2021 20:30
Business, 24.03.2021 20:30
Arts, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
History, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
Social Studies, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
Mathematics, 24.03.2021 20:30
Spanish, 24.03.2021 20:30