Engineering, 25.03.2020 06:41 roblesjairus

A piston-cylinder device contains 1.2 kg of saturated water vapor at 200°C. Heat is now transferred to steam, and steam expands reversibly and isothermally to a final pressure of 800 kPa. Determine the heat transferred and the work done during this process.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.

Answers: 2

Answer

Engineering, 06.07.2019 03:30

The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.

Answers: 2

Answer

Engineering, 11.07.2019 00:40

Along 8-cm diameter steam pipe whose external surface temperature is 90°c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 50°c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 10°c, determine (i) the length of the tube for an exit temperature of air to be 40 °c (ii) the rate of heat transfer from the air and (iii) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 2

Answer

You know the right answer?

A piston-cylinder device contains 1.2 kg of saturated water vapor at 200°C. Heat is now transferred...

Questions