Write an ALP to find cube of N 8-bit numbers in an array using 8086:

ALP for cube of N 8 bit numbers in an array using 8086 is described below.

Explanation:

To solve this problem, we are taking the size of the array into the CL register, and make CH = 00H for counting. Now from each location take the number into accumulator, to make cube, we have to multiply it three times. so we are storing the number temporarily into another register, then multiply AL with AL, and then AL and the value again from that stored location. Thus the cube is generated. After that it is again stored into memory location.

Input            Memory Address (Offset)      

04                                  500

03                                   501

01                                    502

02                                  503

05                                   504

                             

Algorithm –

Store 500 to SI and Load data from offset 500 to register CL and set register CH to 00 (for count). Increase the value of SI by 1. Load number(value) from offset SI to register AL. Move the value of register AL to BL. Multiply the value in register AL by itself. Multiply the value in register AL by BL. Store the result (value of register AL ) to memory offset SI. Increase the value of SI by 1. Loop above 6 till register CX gets 0.

MEMORY               MNEMONICS        COMMENT

ADDRESS

400                              MOV SI, 500  SI<-500

403                             MOV CL, [SI]  CL<-[SI]

405                              MOV CH, 00  CH<-00

407                              INC SI                  SI<-SI+1

408                              MOV AL, [SI]   AL<-[SI]

40A                              MOV BL, AL   BL<-AL

40C                              MUL AL           AX=AL*AL

40E                              MUL BL           AX=AL*BL

410                              MOV [SI], AL   AL->[SI]

412                              INC SI                   SI<-SI+1

413                              LOOP 408           JUMP TO 408 IF CX!=0 and CX=CX-1

415                              HLT                   end

Explanation –

MOV SI, 500: set the value of SI to 500 MOV CL, [SI]: load data from offset SI to register CL MOV CH, 00: set value of register CH to 00 INC SI: increase value of SI by 1. MOV AL, [SI]: load value from offset SI to register AL MOV BL, AL: move value of register AL to BL. MUL AL: multiply value of register AL by AL. MUL BL: multiply value of register AL by BL. MOV [SI], AL: store value of register AL at offset SI. INC SI: increase value of SI by 1. LOOP 408: jump to address 408 if CX not 0 and CX=CX-1. HLT: stop

Idon’t know what the answer is i wish i could

Idon’t do engeneering classes sorry