Engineering, 26.03.2020 00:54 denaemarie02

A strip of high-strength steel has a length of 30 cm and cross section of 1 mm × 20 mm. The modulus of elasticity is 200 GPa, and Poisson’s ratio is 0.27. It is subjected to an axial load of 15,000 N, and it is instrumented with two axial strain gages, with R = 120 Ω and a gage factor of 2.10. These two gages are connected into opposite legs of a Wheatstone bridge (R1 and R3). The two fixed resistors are also 120 Ω, and the supply voltage is 2.5 V. The bridge is adjusted to zerovoltage output before the load is applied. Find the output of the bridge with the load applied.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

You know the right answer?

A strip of high-strength steel has a length of 30 cm and cross section of 1 mm × 20 mm. The modulus...

Questions