ET 344: Industrial Electronics and control
01. A single-phase full wave rectifier is operated f...
Engineering, 29.03.2020 23:57 finesser16
ET 344: Industrial Electronics and control
01. A single-phase full wave rectifier is operated from a 120 V, 60 Hz power supply. A 100-ohm
resistive load is connected at the output terminal of the rectifier. Determine-
a. Maximum power that can be delivered by the rectifier?
b. If it is required to obtain an output voltage 60% of the maximum possible output voltage
then calculate-
i. Delay angle of the Thyristor based rectifier
ii. Average output current, and
ili. Average Thyristor current.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
Questions
English, 03.03.2021 17:20
Mathematics, 03.03.2021 17:20
Mathematics, 03.03.2021 17:20
Biology, 03.03.2021 17:20
Mathematics, 03.03.2021 17:20
Mathematics, 03.03.2021 17:20
Mathematics, 03.03.2021 17:20
