subject
Engineering, 30.03.2020 15:37 tilly40oooo

You have a secret key to access your crypto assets in your company, and you want to share among 3 people, yourself (CEO), your CFO, and your Treasurer. To achieve this goal, you decide take your secret and cut it into three equal non-overlapping parts to give to each of the there people. Which of the following would be the downsides of this scheme?
A) If one of the three goes rogue or loses the secret, you lose ability to access to your assets.
B) An attacker can steal any one secret and get access to your assets.
C) An attacker gains information about your private key material from stealing any one secret, reducing brute force attack space.
D) The access key has to be reconstituted in one place to sign any transactions or decrypt data, and is vulnerable to compromise at that time.
E) Secret information must be somehow securely communicated to multiple parties.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
You have a secret key to access your crypto assets in your company, and you want to share among 3 pe...
Questions
question
Mathematics, 25.09.2019 11:10
question
Geography, 25.09.2019 11:10
Questions on the website: 13722360