Engineering, 30.03.2020 16:19 anaroles04

A disk with diameter = 40 cm and thickness = 5 cm is cast of pure aluminum in an open mold casting operation. Aluminum melts at 660°C, but the pouring temperature will be 800°C. The heat of fusion of aluminum = 398 J/g. Other properties can be found in Tables 4.1 and 4.2. Assume the specific heat has the same value for solid and molten aluminum.

Compute

(a) the unit energy for melting and pouring and
(b) the total energy to heat the metal to the pouring temperature starting from a room temperature of 25°C.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

A disk with diameter = 40 cm and thickness = 5 cm is cast of pure aluminum in an open mold casting o...

Questions