Engineering, 30.03.2020 17:04 mckenziew6969
Which of the 3 days would be considered the most bullish? Explain why. (Select the best choice below.)
A. More stocks rose than fell on all three days. Hence the numerator is always greater than 1.0.
B. Higher TRIN values are interpreted as being bad for the market, because even though more stocks rose than fell, the trading volume in the falling stocks was greater.
C. On day 2, the volume of declining issues exceeded the volume of increasing issues, resulting in a denominator that was less than 1.0.
D. All of the above statements are correct.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
You know the right answer?
Which of the 3 days would be considered the most bullish? Explain why. (Select the best choice below...
Questions
Mathematics, 20.04.2020 22:14
Chemistry, 20.04.2020 22:14
Mathematics, 20.04.2020 22:14
English, 20.04.2020 22:14
Social Studies, 20.04.2020 22:14
Social Studies, 20.04.2020 22:14
Mathematics, 20.04.2020 22:14
Mathematics, 20.04.2020 22:14
