subject
Engineering, 30.03.2020 19:39 freshboiced7

A pump is connected to an electric motor. The motor is supplied with 2 A of current from a 12 VDC source (VDC = direct current volts). The apparatus is run steadily for 60 seconds, and the following measurements are recorded: • mass of fluid collected: 750 grams (0.75 kg) • diameter of exit tube: 0.5 inch (0.0127 m) • density of water: 1000 kg/m3 • height of fluid exit above reservoir: 36 inches (0.9144 m) • remember that g=9.81 m/s2 (g is the gravitational constant … you need this to find weight!)

Find:

a) the weight of the fluid collected

b) fluid velocity at exit in m/s (meters per second)

c) flow rate in L/min (1 liter = 0.001 m3)

d) system efficiency (express as a percentage)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
A pump is connected to an electric motor. The motor is supplied with 2 A of current from a 12 VDC so...
Questions
question
Mathematics, 04.03.2021 20:10
question
Mathematics, 04.03.2021 20:10
question
Mathematics, 04.03.2021 20:10
question
Mathematics, 04.03.2021 20:10
question
English, 04.03.2021 20:10
question
Social Studies, 04.03.2021 20:10
Questions on the website: 13722363