subject
Engineering, 31.03.2020 21:47 jetblackcap

A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facility can supply up to 10 Mgal/day of additional water with a BOD of 50mg/L, and a local stream can supply an additional 2 Mgal/day with a BOD of 200 mg/L. After use, the factory discharges the water is used to a local river. The concentration of biochemical oxygen demand (BOD) in the wastewater released to a nearby river must be less than 100mg/L. The cost of water is $1000/Mgal from the water supply facility and $150/Mgal from the local stream. The factory has obtained financing that allows them to spend no more than $3500/day on water.
a. Formulate a systems model and find the minimum cost solution that satisfies all constraints.
b. Then, reformulate the model for minimum discharge BOD solution that satisfies all constraints.
c. Plot the two solutions to the previous problem on a graph that has cost on the horizontal axis and BOD on the vertical axis. Draw a line connecting these two different optima and determine the slope of that line.
d. Propose a new environmental policy that would cause a profit-maximizing factory manager to put in place the BOD-minimizing design.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
You know the right answer?
A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facilit...
Questions
question
Mathematics, 05.05.2020 03:44
question
Law, 05.05.2020 03:44
question
Mathematics, 05.05.2020 03:44
question
History, 05.05.2020 03:44
question
Chemistry, 05.05.2020 03:44
Questions on the website: 13722367