Engineering, 01.04.2020 16:09 bvbbridesmaid5519
It has been stated that the quality of the sheared edges can influence the formability of sheet metals. Explain why
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26Ā°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70Ā°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
It has been stated that the quality of the sheared edges can influence the formability of sheet meta...
Questions
Chemistry, 11.10.2019 17:20
Mathematics, 11.10.2019 17:20
Health, 11.10.2019 17:20
Business, 11.10.2019 17:20
Mathematics, 11.10.2019 17:20
Mathematics, 11.10.2019 17:20
Health, 11.10.2019 17:20
Mathematics, 11.10.2019 17:20
