Engineering, 04.04.2020 01:32 liliJ

A section of a freeway ramp has a 4.0% grade and ends at station 127 00 and elevation 138 ft. It must be connected to another section of the ramp (which has a 0.0% grade) that is at station 162 00 and elevation 97 ft. It is determined that the crest and sag curves required to connect the ramp should be connected (the PVT of the crest and PVC of the sag) with a constant-grade section that has the lowest grade possible. Design a vertical alignment to connect between these two stations using a 50-mi/h design speed. Provide the lengths of the curves and constant-grade section.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

You know the right answer?

A section of a freeway ramp has a 4.0% grade and ends at station 127 00 and elevation 138 ft. It mus...

Questions