Engineering, 04.04.2020 11:10 mandilynn22
A 20 mm diameter cylindrical rod fabricated from a 2014-T6 alloy is subjected to repeated tension-compression load cycling along its axis. The magnitudes of the maximum tensile and compressive stresses during cycling are 600 MPa and 100 MPa, respectively. Estimate the fatigue lifetime of this cylindrical rod (in years), if it is cycled between these stress states sinusoidally with a frequency of 0.01 Hz. You may assume that the curves represent a 100% chance of failure.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
A 20 mm diameter cylindrical rod fabricated from a 2014-T6 alloy is subjected to repeated tension-co...
Questions
Biology, 29.10.2019 04:31
English, 29.10.2019 04:31
Mathematics, 29.10.2019 04:31
Mathematics, 29.10.2019 04:31
Biology, 29.10.2019 04:31
