Unwanted resistance is being discussed.
Technician A says that unwanted resistance can be caus...
Engineering, 05.04.2020 07:05 ayoismeisalex
Unwanted resistance is being discussed.
Technician A says that unwanted resistance can be caused by a loose ground connectic
Technician B says that unwanted resistance can be caused by corrosion at a connectior
Who is correct?
a. Technician A
c. Both Technician A and B
b. Technician B
d. Neither Technician A nor Technician B
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
You know the right answer?
Questions
Social Studies, 30.03.2020 23:38
Mathematics, 30.03.2020 23:39
Computers and Technology, 30.03.2020 23:39
Mathematics, 30.03.2020 23:39
Mathematics, 30.03.2020 23:39
History, 30.03.2020 23:39
