Engineering, 06.04.2020 23:20 dakotalynnwillis01

A certain practical current source provides 0.680555555555555 W to a 50 Ω load. That same practical current source provides 1.11783376314223 W to an 460 Ω load. If the same practical current source had a resistance RL is connected to it, creating a voltage across RL of vL and a current through RL of iL. Find the values of RL, vL, and iL if
(a) vL×iL is maximum
(b) vL is a maximum
(c) iL is a maximum.

(a) RL = Ω , vL = V , iL = A
(b) RL = Ω , vL = V , iL = A
(c) RL = Ω , vL = V , iL = A

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

A certain practical current source provides 0.680555555555555 W to a 50 Ω load. That same practical...

Questions