subject
Engineering, 07.04.2020 16:20 tinaxiao

You are given the 500-mb heights and absolute vorticity maps at 12Z on December 31. You are also given near-surface temperatures (40 meters above the ground) for the same time.

12Z 12/31 500-mb Heights
12Z 12/31 500-mb Abs. Vorticity
12Z 12/31 40m Temperature

At the time the seed of the snowstorm started to sprout, there was a potent short-wave trough at 500 mb associated with a powerful surface low-pressure system that was moving away from the coast of Maine. There was also a short-wave trough at 500 mb over the upper Middle West associated with an "Alberta Clipper", which is a modest surface low-pressure system that usually brings only a nuisance snow along and north of its path. The reason I mention these two systems is that I want to point you away from them. Just so you won't get confused -- neither one of these systemsserved as the catalyst for triggering the low-pressure system that ultimately dumped heavy snow in eastern Pennsylvania. In other words, ignore these two short-wave troughs!

At this time a weak surface low has just formed. Complete the following statement: The newly formed surface low is located at approximately N W (latitude/longitude... ex. "36N 70W") and (relative location... ex. "east/west", "upstream/downstream", etc ) of the 500-mb short wave trough axis. Note: A range of values will of course be accepted for the longitude/latitude estimate of the surface low's position.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
question
Engineering, 04.07.2019 19:20
Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection
Answers: 1
question
Engineering, 04.07.2019 19:20
List 3 options on how to reduce knocking problens during engine process,
Answers: 2
You know the right answer?
You are given the 500-mb heights and absolute vorticity maps at 12Z on December 31. You are also giv...
Questions
question
Chemistry, 10.12.2021 05:30
question
Physics, 10.12.2021 05:30
question
Mathematics, 10.12.2021 05:30
question
Physics, 10.12.2021 05:30
question
Mathematics, 10.12.2021 05:30
question
Mathematics, 10.12.2021 05:30
Questions on the website: 13722360