Engineering, 10.04.2020 02:49 jmcd10

The value of the resistor is R=8Ω. Assume that at the instant the 2 A dc current source is applied to the circuit, the initial current in the 25 mH inductor is 1 A, and the initial voltage on the capacitor is 50 V (positive at the upper terminal).

a. Find the derivative of the inductor current iL(t) at time t=0+
b. Find the differential equation satisfied by the inductor current, iL(t) for t>0 . Write the differential equation in the form ad2iL/dt2+bdiL/dt+iL(t)=c , where a, b,c are constants. Find the values of a, b,c .
c. Find the roots of the characteristic equation associated with the differential equation you found in Part B. Enter the roots s1,s2 in units of rad/sec separated by a comma. For real roots, enter the smallest root first. For complex roots, enter the root with the positive imaginary part first.
d. Find iL(t) for t≥0.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

You know the right answer?

The value of the resistor is R=8Ω. Assume that at the instant the 2 A dc current source is applied t...

Questions