Question 21(Multiple Choice
(Lesson 5.5 LC)
While driving under normal conditions, which...
Engineering, 10.04.2020 18:14 duhitzmay9395
Question 21(Multiple Choice
(Lesson 5.5 LC)
While driving under normal conditions, which of the following principles should be used to keep the appropriate distance between your vehicle and the vehicle in front
of you?
O one second
two seconds
three seconds
O four seconds
Question 22 Multiple Choice Worth 3 points)
(Lesson 3.4 LC)
Answers: 3
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12Β°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Chemistry, 25.02.2021 23:50
Computers and Technology, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50
English, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50
Chemistry, 25.02.2021 23:50
Social Studies, 25.02.2021 23:50
Engineering, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50
Computers and Technology, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50
Mathematics, 25.02.2021 23:50