Engineering, 14.04.2020 16:32 mariamakonteh31

A countershaft in a machine has two pulleys mounted on it for power transmission and is supported by cylindrical roller bearings at the ends. The countershaft runs at 1,500 revolutions per minute. The belt tension on the loose side of Pulley 1 is 15% of the tension on tight side. The pulleys are 50 mm wide. The bearings must have a minimum life of 90,000 hours. Design the shaft, mounting components and bearings. The design will include the following items. (1) Shaft material selection (2) Shaft diameters at critical locations along the shaft (using a factor of safety of 1.5) (3) Selection and design of the components needed for mounting the shaft and bearings (4) Selection and design of bearings (5) A CAD drawing of the shaft layout

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

You know the right answer?

A countershaft in a machine has two pulleys mounted on it for power transmission and is supported by...

Questions