Engineering, 15.04.2020 03:27 jordantay208

For the next two parts we will use the following relationship between the input and output voltage which you should have found in solving for part B: vo(t)=vin(1−e−αt(cos(βt)+αβsin(βt)) )vo(t)=vin(1−e−αt(cos(βt)+αβsin(βt) )) , where α=11389α=11389 rad/sec and β=27553β=27553 rad/sec and time is now measured in seconds. What is the largest dc voltage, vinvin that we can use at the input without causing the op-amp to saturate? Enter your answer with appropriate units and round your answer to three significant digits. Warning: In order to find when vo(t)vo(t) reaches its peak value you will need to solve dvodt=0dvodt=0 . The output voltage has many local maxima and minima. Make sure you get the right one. A plot of vo(t)vo(t) vs. tt will be helpful in guiding you to the right solution.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

For the next two parts we will use the following relationship between the input and output voltage w...

Questions