Engineering, 15.04.2020 20:20 estefaniapenalo

Consider the following sets of values: R = 100 Ω, L = 0.4 H, and C = 0.5 µF. R = 100 Ω, L = 0.4 H, and C = 10 µF. R = 100 Ω, L = 0.4 H, and C = 200 µF. Assume the elements are attached in parallel. For each set of values, answer the following: (a) Is the circuit overdamped, underdamped, or critically damped? (b) What are the roots of the characteristic polynomial? Now assume the elements are attached in series. For each set of values, answer the following: (c) Is the circuit overdamped, underdamped, or critically damped? (d) What are the roots of the characteristic polynomial?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Apinion having 30 involute teeth of 6,5 module rotates at 220 r/min and transmits 2 kw to a gear wheel having 70 teeth; the addendum on both wheels is 4 of the circular pitch and the angle of obliquity is 200. determine; 3.1 the lengths of the path of approach and the arc of approach 3.2 the normal force between the teeth at an instant when there is only one pair of teeth in contact

Answers: 2

Answer

You know the right answer?

Consider the following sets of values: R = 100 Ω, L = 0.4 H, and C = 0.5 µF. R = 100 Ω, L = 0.4 H, a...

Questions