Engineering, 15.04.2020 23:12 tysongraham5232

Consider two designs for the 5-stage pipelined architecture. In the first design, the branch condition and target are resolved in the MEM stage, while in the second design, the branch condition and target are resolved in the ID stage, but the clock cycle time is 10% larger than in the first design. Assuming that I. the instruction mix executing on the pipeline contains 25% branch instructions, 70% of which are taken. II. the CPI of both designs is 1.5 if we do not account for stalling due to control hazards. a. Compute the CPI for each of the two designs when the effect of control hazards is accounted for. b. Specify which of the two designs would be more efficient.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

Consider two designs for the 5-stage pipelined architecture. In the first design, the branch conditi...

Questions