Engineering, 16.04.2020 00:45 daniel1480

A rigid copper tank, initially containing 1 m3 of air at 295 K, 5 bar, is connected by avalve to a large supply line carrying air at 295 K, 15 bar. The valve is opened only as long as required tofill the tank with air to a pressure of 15 ,bar at which point the air in the tank is at 310 .K The copper tank, which has a mass of 20 ,kg is at the same temperature as the air in the tank, both initially and finally. Thespecific heat of the copper is c= =0.38kJ/(kg-KK). You may ignore kinetic and potential energy effects. Assuming ideal gas behavior for the air, determine (a) the initial and final mass of air within the tank and(b)the heat transfer to the surroundings from the tank and its contents, in kJ, ignoring kinetic and potential energy effects.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

You know the right answer?

A rigid copper tank, initially containing 1 m3 of air at 295 K, 5 bar, is connected by avalve to a l...

Questions