Engineering, 16.04.2020 04:04 sumayyahjj

Isye 6501 Analytics-Success-Stories (among others) contain brief overviews of some major Analytics success stories. In this course project, your job is to think carefully about what analytics models and data might have been required. (1) Browse the short overviews of the projects. Read a bunch of them – they’re really interesting. But don’t try to read them all unless you have a lot of spare time; there are lots! (2) Pick a project for which you think at least three different Analytics models might have been combined to create the solution. (3) Think carefully and critically about what models might be used to create the solution, how they would be combined, what specific data might be needed to use the models, how it might be collected, and how often it might need to be refreshed and the models re-run. DO NOT find a description online (or elsewhere) of what the company or organization actually did. I want this project to be about your ideas, not about reading what someone else did. (4) Write a short report describing your answers to (3).

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

Isye 6501 Analytics-Success-Stories (among others) contain brief overviews of some major Analytics s...

Questions