Engineering, 17.04.2020 21:05 aliciabenitez

A fluid flows through a pipe with inside diameter D = 0.12 m and length L = 75 m. The flow rate of the fluid is 0.26 kg/s. The pipe is maintained at a constant surface temperature of Ts and the flow may be considered fully-developed along the entire length. The fluid enters the pipe with mean temperature Tm, i = 320 K, and exits with a mean temperature Tm, o = 435 K.

The average properties of the fluid are: Pr = 75, Thermal conductivity k = 0.55 W/m K, Density p = 1100 kg/m3, Specific heat c = 1850 J/kg K, Absolute viscosity it = 0.0075 N s/m2.

(i) Calculate the surface temperature of the pipe, 'Ts, necessary for this outlet temperature.
(ii) Calculate the total heat transfer
(iii) Plot the mean temperature, T., and Ts as a function of x.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An external consultant recommends that a plant installs a bank of capacitors for power factor correction. this will reduce the peak electrical demand charges by an average of 93 kw every month. the plant current pays $13 per kw in peak demand charges. the capacitor bank will include 223 kw of fixed capacitors, and 183 of variable capacitors. the fixed capacitors cost $59 per kw, and the variable capacitors will cost $65 per kw. the consultant charges 21% of the equipment costs to install the capacitors. because this project will reduce the demand for the electric utility, they are prepared to provide a one-time rebate of $42 per kw of reduced demand. what is the simple payback period for this project (in years)?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

A fluid flows through a pipe with inside diameter D = 0.12 m and length L = 75 m. The flow rate of t...

Questions

SAT, 20.07.2019 20:30

Which of the following is not an accurate statement about the attitude of teenagers when driving...