Engineering, 20.04.2020 19:59 Shaynele
A shaft is loaded in bending and torsion such that Ma = 70 N ? m, Ta = 45 N ? m, Mm = 55 N ? m, and Tm = 35 N ? m. For the shaft, Su = 700 MPa and Sy = 560 MPa, and a fully corrected endurance limit of Se = 210 MPa is assumed. Let Kf = 2.2 and Kfs = 1.8. With a design factor of 2.0 determine the minimum acceptable diameter of the shaft using
a. ) DE-Gerber criterion.
b) DE-ASME Elliptic criterion.
c) DE-Soderberg criterion.
d) DE-Goodman criterion.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
A shaft is loaded in bending and torsion such that Ma = 70 N ? m, Ta = 45 N ? m, Mm = 55 N ? m, and...
Questions
SAT, 29.12.2021 04:50
Chemistry, 29.12.2021 04:50
SAT, 29.12.2021 05:00
SAT, 29.12.2021 05:00
Physics, 29.12.2021 05:00
SAT, 29.12.2021 05:00
Mathematics, 29.12.2021 05:00
