Engineering, 21.04.2020 16:22 jakaylathomas11

A cyclone is operated in a closed circuit with a ball mill. The cyclone is feed from a rod mill with a slurry that has a density of 1250 kg/m3 while the solid bulk density is 2900 kg/m3. Cyclone overflow goes to flotation circuit consists of a rougher, a scavenger and one cleaner cell. The slury feed to the rougher has 15% solids (overflow) while the feed to ball mill (underflow) from the cyclone has 50% solids with a mass flow rate of 40 t/h.

• Draw a possible flow sheet of the process
• Calculate the mass flow rate of the feed from rod mill to cyclone (hint: you need to calculate % solids in feed and dilution ratios)
Get more help from Chegg

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

A cyclone is operated in a closed circuit with a ball mill. The cyclone is feed from a rod mill with...

Questions