Engineering, 21.04.2020 17:34 BlehBlah1441

G Your program should read in a list of jobs from a tab-delimited text file named jobs. txt. The format of the text file should have one line for each job, where each line has a job name, a start time and a duration. The job name must be a letter from A-Z. The first job should be named A, and the remaining jobs should be named sequentially following the alphabet, so if there are five jobs, they are named A-E. The arrival times of these jobs should be in order.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

G Your program should read in a list of jobs from a tab-delimited text file named jobs. txt. The for...

Questions